10In order to perform each of the following six functions, the lock must rst be placed in Programming Mode:*If no input within 10 seconds, Yellow LED
11IN8-MODKEYPADLL 02/26/2013Restoring the Lock to Factory Default Setting• Remove power (disconnect 9V battery) from Lock • Press and Hold EMTEK but
ASSA ABLOY is the global leader in door opening solutions, dedicated to satisfying end-user needs for security, safety and convenience.Copyright © 201
23694b24a4d481ITEM NO. DESCRIPTION QTY.1 Key 22 Outside Trim Plate Assembly 13 Adjustable Latch for 2 ⁄” or 2 ¾” Backset 14 Inside Trim Plate Assemb
32 ⁄” or 2 ¾” Backset2 ⁄” Dia Bore⁄” Deep2 ¼”1 “1” Diameter Edge Bore2. Door Prep 3. Door Jamb Prep1. Conrm HandingHANDING OF DOOR IS ALWAYS D
4Use a Phillips head screwdriver to remove screws (item #4c) shown below and detach Inside Trim Plate from the Inside Chassis.Fasten Adjustable Latch
64. Install Inside ChassisCAM LINK MUST REMAIN IN THE CORRECT POSITION DURING INSTALLATION.!Step 1: Conrm the position of Cam Link.For Left Hand Loc
7CHECK ALIGNMENT BEFORE FULLY TIGHTENING SCREWS.!Step 4: Connect Wire Harness (A) and tuck Connectors as shown (B).ABStep 5: Install Battery.For op
8!USER CODES ARE LOCATED ON THE INSIDE TRIM PLATE & ON PAGE 11.5. Install Inside Trim PlateInside Screws (item #4c)Fasten Inside Trim Plate using
9112EMTE KYour Emtek lock is shipped with two 4-digit user codes and a 6-digit programming code. These codes are randomly generated at the factory. (T
Kommentare zu diesen Handbüchern